工地围挡的挡风阻系数高吗？这个问题是不少施工者的疑惑，下面就让工程围挡厂家为您分析吧。

Is the wind resistance coefficient of site enclosure high? This problem is puzzled by many constructors. Let the engineering enclosure manufacturer analyze it for you.

采用锁定C型钢龙骨，省去了传统线钩的安装步骤，提高了安装施工效率，增加了抗风和抗冲击能力。结构缺陷：围板加强筋采用角铁，彩钢板与角铁背筋分开组装后，用专用铁丝钩将围板与角铁连接。

The adoption of locking C-shaped steel keel eliminates the installation steps of traditional wire hook, improves the installation and construction efficiency, and increases the wind and impact resistance. Structural defect: the stiffening bar of the coaming is made of angle iron. After the color steel plate and the angle iron back bar are assembled separately, the coaming is connected with the angle iron with a special wire hook.

这三个因素不能紧密结合形成整体应力。当风力上升受外力影响时，角铁背筋容易扭曲变形，挂钩容易脱落，稳定性、性、抗风能力较差，不能满足施工方防护的使用要求，实用性大大降低。面板设计不合理，彩钢薄而尖，面板边缘没有保护，容易割手伤人。施工缺陷：常规2.5米高的围护结构中使用了三个角钢加强筋，需要安装30多个挂钩才能将工地围挡与加强筋连接起来。安装或拆卸过程很麻烦。

These three factors cannot be closely combined to form the overall stress. When the wind rises and is affected by external forces, the angle iron back reinforcement is easy to twist and deform, the hook is easy to fall off, and the stability, safety and wind resistance are poor, which can not meet the use requirements of the safety protection of the construction party, and the practicability is greatly reduced. The panel design is unreasonable, the color steel is thin and sharp, the panel edge is not protected, and it is easy to cut hands and hurt people. Construction defect: three angle steel stiffeners are used in the conventional 2.5 meter high enclosure structure, and more than 30 hooks need to be installed to connect the site enclosure with the stiffeners. The installation or removal process is very troublesome.

不易分离，整体强度增加，工地围挡采用凹凸槽组装，彩钢边内后沿的设计既能起到夹点的作用，又能防止刀具在组装时受伤，使施工更加方便。安装过程简化，安装效率提高：施工时先安装龙骨，然后将龙骨扣放入左侧龙骨卡点即可安装面板，单人即可完成组装施工。

It is not easy to separate, and the overall strength is increased. The site enclosure is assembled with concave and convex grooves. The design of the inner and rear edges of the color steel can not only play the role of pinch points, but also prevent the tool from being injured during assembly, making the construction more convenient. The installation process is simplified and the installation efficiency is improved: install the keel first during construction, and then put the keel buckle into the left keel clamp point to install the panel. A single person can complete the assembly construction.

此外在围挡施工场地中要配备垃圾袋。所有建筑垃圾、地面灰尘等。必须清洗、装袋并运走。如果垃圾装袋后48小时内未及时运输，应在施工现场设置临时堆放场。施工现场每天都要定期洒水，减少灰尘，洒水的频率应以施工现场地面不产生灰尘为依据。

In addition, environmental protection garbage bags shall be provided in the enclosure construction site. All construction waste, ground dust, etc. Must be cleaned, bagged and transported away. If the garbage is not transported in time within 48 hours after bagging, a temporary storage yard shall be set up at the construction site. The construction site shall be regularly watered every day to reduce dust, and the frequency of watering shall be based on the fact that no dust is generated on the ground at the construction site.

堆放易产生粉尘的材料，应采取覆盖防尘网、喷洒抑尘剂或洒水等措施。出入口应安装自动埋胎清理机，以保证正常使用。严禁车辆携带泥沙出门。

For stacking materials prone to dust, measures such as covering dust screen, spraying dust suppressant or watering shall be taken. The entrance and exit shall be equipped with automatic buried tire cleaning machine to ensure normal use. It is strictly forbidden for vehicles to carry sediment out.

工地围挡的挡风阻系数高吗？从以上的讲解内容，我们可以知道，此围挡的挡风系数不错，您还有什么问题要了解可以随时来我们网站http://www.jnpfjc.com咨询！

Is the wind resistance coefficient of site enclosure high? From the above explanation, we can know that the wind resistance coefficient of this fence is good. If you have any questions, please come to our website at any time http://www.jnpfjc.com consulting service