围挡施工现如今应用的范围非常的广泛，当然其中的要求也是要遵守，能够更多的进行施工以及更好的保护好人员，那么下面来讲三种类型的围挡施工做法吧。

　　Enclosure construction is now used in a very wide range, of course, the requirements are also to comply with, can be more construction and better protection of personnel safety, then the following three types of enclosure construction practices.

　　园林绿化工程围挡使用要求：

　　该围挡用于7天以内的园林绿化工程。围挡两侧支架端部设置不少于100公斤的砂袋做压重。围挡下脚用油漆喷刷成黄黑相间交通斑马纹，斑马纹高200mm、宽150mm、倾斜角45度，倾斜角指向车辆行驶方向。

　　Requirements for the use of enclosure in landscape engineering:

　　The enclosure is used for landscaping projects within 7 days. The end of the bracket on both sides of the enclosure should be equipped with sand bags of no less than 100 kg as the pressure. The lower foot of the fence is sprayed with paint into yellow and black traffic safety zebra grain, zebra grain 200mm high, 150mm wide, inclination Angle of 45 degrees, inclination Angle points to the direction of the vehicle.

　　应急抢险工程围栏的要求：

　　应急抢险围栏框架采用DN25的1寸镀锌管，围栏采用1.2mm镀锌板制作。应急抢险围栏采用插销连接。应急抢险围栏表面应粘贴反光膜。应急抢险围栏上应注明抢险工程类型及建设单位名称。

　　Requirements of emergency rescue engineering fence:

　　The frame of emergency rescue fence is made of DN25 1-inch galvanized pipe, and the fence is made of 1.2mm galvanized sheet. The emergency rescue fence is connected by bolt. Reflective film shall be pasted on the surface of emergency rescue fence. Type of emergency rescue project and name of construction unit shall be indicated on the emergency rescue fence.

　　交叉路口围挡的要求：

　　距离交叉路口20m范围内的机动车道的施工围挡，围挡距地面0.8m以上部分应当采用通透性围挡，不得造成视觉、听觉的盲区。围挡下面安装交通反光条，每6m在立柱上安装警示灯。围挡材料及下脚基座参照市政道路工程围挡要求设置。

　　Requirements for intersection enclosure:

　　For the motor vehicle road construction enclosure within 20m distance from the intersection, transparent enclosure shall be used for the part above 0.8m distance from the ground, which shall not cause blind areas of vision and hearing. The traffic safety reflective strip is installed below the enclosure, and the warning light is installed on the column every 6m. Enclosure material and foot base shall be set according to the requirements of municipal road engineering enclosure.

　　临街端头及大门围挡防护要求：

　　临街端头围挡必须进行封阻，或设置大门。应设置交通标识、警示灯及防撞桶。围挡材料参照市政道路工程围挡要求设置，下脚用油漆喷刷成黄黑相间交通斑马纹，斑马纹高200mm、宽150mm、倾斜角45度，倾斜角指向车辆行驶方向。

　　Street end and gate enclosure protection requirements:

　　Street end enclosure must be blocked, or set a gate. Traffic safety signs, warning lights and anti-collision barrels should be set up. Enclosure material is set according to the requirements of municipal road engineering enclosure, and the lower foot is sprayed with paint into yellow and black traffic safety zebra pattern. The zebra pattern is 200mm high, 150mm wide, and the inclination Angle is 45 degrees. The inclination Angle points to the direction of the vehicle.

　　在此讲解了三种类型的围挡施工做法，除此之外，还有夹芯彩钢板围挡、PVC材料围挡等围挡的施工做法，详细的要求您可以来我们网站www.jnpfjc.com咨询了解！

　　In this explained three types of enclosure construction practices, in addition, there are sandwich color steel plate enclosure, PVC material enclosure and other enclosure construction practices, detailed requirements you can come to our website www.jnpfjc.com consultation understanding!